Indexes by capital letter go for measurements to be taken, f.e. Cc for circumference for Chest.
Circumferences are taken in full size but recorded in half ones as the pattern cut out is to be created for one-half.
So, following measurements are required to create a pattern cut out.
Half neck size (Hn) to be measured for neck sze (Fn)
Half chest (Hc) to be measured for chest size (Fc) shoulder bones and extending chest parts along
Half waist (Hw) to be measured for waistline (Fw) horizontally along the narrow part (where tied)
Half thigh (Ht) to be measured for thigh size (Ft) horizontally body round, back on extending bottom parts along, in front, taking into account extending belly parts.
Chest width (Wc) to be measured horizontally between arms and body linkage. To be recorded in halfsize.
Back width (Wb) to be measured horizontally shoulder blade along between arms and body linkage. To be recorded in half.
Back until waistline length (Lbw) to be measured from 7th neck-bone until waistline.
Back length (Lb) to be measured from 7th neck-bone until the needed length, holding measurement tape on waistline.
Shoulder slope width (Wss) to be measured from neck shoulder point until shoulder. Sleeve length (Ls) to be measured along with Shoulder width (Ws), until needed sleeve length. Then the shoulder width to be calculated, allowing measurements to be taken in the proper way.
